How to tie a feeder?
Watch the video
An experienced anglerSpiral gear, which they fill with bait - feeding. Thus, the fish feed from this gear, coming closer and closer to the hook, which makes it easier to catch. How to tie a feeder to get a good catch?
Tying the trough
The feeder can be attached directly to theline. Many people do that. However, fishermen with experience advise to attach it to the line through a carbine. That is, with the help of a special fastener - so you can much faster change gear, unfastening the old and fastening the new with a special mount. By tying the feeder to the line itself, you will have to cut the line in case of need, and then also unravel the nodules. This is long and difficult.
A lot of nodes are used to tie the trough through the rifle. Consider the two most popular and strong.
The line is threaded into the eye of the carbine, thenwith its free end from the bottom up begin to wind the main line. After 7-10 revolutions, the free end is passed into the loop formed at the eye of the carbine. Then the assembly is wetted and slowly tightened. The free end is cut off.
It's called Offshore Swivel-Knot. We thread a loop in the eye of the carbine, raise the loop up to the ends of the line, and the carbine must hang down. Now we wrap the carbine around ourselves. The scaffold curls from the inside. After 5-7 turns wet the knot and slowly tighten it.
On other tricks and adaptations of anglers, see Fishing tackle.