How to make a lightsaber?

Watch the video

How to make a lightsaber?

Light Sword - a weapon of science fictionmovies. The blade of the lightsaber shines brightly throughout its entire length. The most famous film with this weapon, Star Wars, was watched by almost everyone. Many people are interested in how to make a real lightsaber on their own. It is not difficult to make such a sword.

We make the sword light

To build a sword light by yourself, you will need the following tools:

  • hacksaw,
  • cutter,
  • drill
  • soldering iron.

If there is no soldering iron, then it does not matter, you cando without it. Any tube approximately 25 cm long can be used for the light sword handle. If the tube is too long, it should be cut off. If desired, the handle of the sword can be decorated. In order for the lightsaber to work, it must have an on / off button. In place of the button, a hole is made in the handles. You should also provide a slot for the battery.

Consider further how to make a lightsaber, andnamely - his blade. The length of the blade is about 75 cm. The length of the blade can be adjusted depending on the growth of the owner of the sword. If the blade is completely transparent, then it needs to be made opaque in order to obtain a scattering light. On one side of the sword we wind the tape around so that the blade snaps into the handle of the sword and does not jump out of it.

Take the two wires, and then completely baretheir. To one of the wires we attach the LED at the very beginning. We fix the other LEDs with light positive contacts to the wire. Then we do everything according to the same scheme with negative LEDs. Some people do crossbars to bind a chain of LEDs. The wires must not touch, otherwise there may be a short circuit. A foil is attached to the edge of the blade for better reflection of light.

Add sound

If you want to know how to make a lightsaber,so that the sword emits characteristic sounds, like in a movie, then a small motor should be attached to it. If the motor is not loosely located in the handle of the sword, it should be wrapped with electrical tape. The wires are connected to the switch using a soldering iron. Then carefully insert all the wires into the handle of the sword. You can add a foil in the form of a reflector at the bottom, which will help the blade to glow brighter. If the sword does not shine, then you need to check the LEDs, if they do not come into contact with each other. The motor shaft must also not come into contact with anything, otherwise it may cause the light sword to be inoperative.

There is an easier way of making such a device. To do this, you need a normal flashlight and a rigid film.

Use of the Light Sword

The analog of the light sword can be created for:

  • carnival,
  • role-playing games,
  • interesting theatrical productions.

Such a lightsaber is everyone's dreamboys and not only. After all, everyone who saw the films, where the Jedi demonstrate perfect possession of such a sword, more than once admired this fantastic weapon and dreamed of having the same.

Related news

How to make a lightsaber

How to make a lightsaber

How to make a lightsaber

How to make a lightsaber

How to make a lightsaber

How to make a lightsaber

How to make a lightsaber

How to make a lightsaber

How to make a lightsaber

How to make a lightsaber

How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber How to make a lightsaber